找诗词>英语词典>planar method翻译和用法

planar method

英 [ˈpleɪnə(r) ˈmeθəd]

美 [ˈpleɪnər ˈmeθəd]

网络  剥层法

计算机

双语例句

  • A planar calibration method of the micro vision measuring system was researched.
    研究了旋转体视显微检测系统的平面标定方法。
  • Investigation of the Uniformity of Resistivity of Silicon Crystals by Planar Four-Probe Method and Square Arrayed Planar Four-Probe Method
    用测试图形和正方阵列机械四探针研究硅单晶电阻率的均匀性
  • In this paper, the target strength ( TS) of mines lying on the seabed was predicted by use of the physical acoustics method and the planar element method.
    文章利用板块元方法和物理声学方法对界面附近目标的目标强度计算理论预报沉底水雷的目标强度。
  • Simulation of Light Distributing in Multi-Layered Tissues in Planar Finite Element Method
    基于二维有限元模拟光在多层组织中的传播
  • The equivalent step planar wave guide method is proposed to study the propagation properties and design of diffused planar wave guide.
    本文引入一种研究扩散光波导传播特性及设计计算的新方法&等效阶跃平板波导方法。
  • This algorithm first uses the planar parameterization method to project the 3D surface to the two-dimensional space. Then it calculates the corresponding cutting way. Based on this way, it cuts triangle mesh. Finally, the algorithm restores triangle mesh to 3D space.
    该算法首先用平面参数化方法将三维曲面投影到二维空间,然后计算相应的切割路径,再根据该路径切割网格模型,最后将切割后的网格模型还原到三维空间完成切割。
  • Using planar wave-front method or shooting in large group interval of shot-array;
    采用平面波前法或用大基距组合激发;
  • By employing planar section method and broken-line method, the root stress of gear teeth under different load levers have been calculated. The macro morphology of fatigue fracture of gear test specimens have been analyzed.
    依据平截面法和折截面法对不同载荷级下的齿根应力进行了计算,并对齿轮试样疲劳断口的宏观形貌进行了分析。
  • In this paper, the existence condition of a crank in the space four-bar linkage RSSP, transmission angle, variation coefficient of travel speed and the motion range of the rocker in the RSSP mechanism are analysed by the planar graphic method.
    本文用平面图解方法分析了空间四杆机构(RSSP)的曲柄存在条件、传动角、行程速度变化系数及摇杆RSSP机构的运动范围。
  • By studying on Jacobin matrix of planar, a method that can make the machine avoid singularity on operating is put forward.
    通过对五杆机构雅可比矩阵的分析,提出了避免机床在工作时出现奇异位形的方法。